Florabest FBLB 33 A1 Manuel d'utilisateur télécharger pdf (Page 11)

GB/IE

- 11 -

•

Push the bottom blower tube (Fig. 3a/ Item

14) over the top blower tube (Fig. 3a/Item

13) and lock by turning clockwise.

•

The blower nozzle with either the large or

small opening can be fitted. Push the blower

nozzles over the blower tube and lock by

turning clockwise.

6.2 Fuel and oil

Use only a mixture of unleaded petrol and special

2-stroke engine oil. Mix the fuel mixture as indica-

ted in the fuel mixing table.

Important: Do not use a fuel mixture which has

been stored for longer than 90 days.

Important: Never use 2-stroke oil with a recom-

mended mixing ratio of 100:1. The manufacturer’s

warranty will be voided in case of engine dama-

ge due to inadequate lubrication.

Important: Only use containers designed and

approved for the purpose to transport and store

fuel.

Pour the correct quantities of petrol and 2-stroke

oil into the attached mixing bottle (see scale prin-

ted on the bottle). Then shake the bottle well.

6.3 Fuel mixture table

Mixing procedure: 40 parts petrol to 1 part oil

Petrol 2-stroke oil

1 liter 25 ml

5 liters 125 ml

7. Operation

Please note that the statutory regulations gover-

ning noise abatement may differ from one loca-

tion to another.

7.1 Cold starts (4a-4b)

Fill the tank with the required amount of oil/petrol

mix. See also „Fuel and oil“.

1. Place the equipment safely and securely on

the ground.

2. Set the On/Off switch (4) to „ON“ (Fig. 4a)

3. Press the fuel pump (10) (Fig. 4b) 10 times.

4. Set the choke lever (7) to „ „.

5. Hold the equipment ﬁ rmly by the holding

handle.

6. Pull the starter cable (8) out a short way until

you feel resistance. It must be pulled evenly

and quickly to start the engine. When the en-

gine is running, set the choke lever to „

„.

7. Allow the engine to warm up for approx. 10

seconds.

Note: If the engine fails to start after repeated

attempts, proceed as described in the section

„Troubleshooting guide“.

Note: Always pull out the starter cable in a

straight line. If it is pulled out at an angle, the

cable will rub against the eyelet. This friction will

cause fraying and therefore greater wear on the

starter cable. Always hold the starter handle se-

curely when the cable is retracted. Take care not

to let the cable snap back after it has been pulled

out. This could cause the cable to catch/become

worn and/or might damage the starter housing.

7.2 Warm starts (engine off for no longer

than 15- 20 minutes)

1. Set the On/Off switch (Figure 1 / Item 4) to

„ON“ and pull the starter cable (Fig. 1/Item

8). The engine should start after one or two

pulls. If the engine does not start after 6 pulls,

repeat steps 2 to 6 (see the section „Cold

starts“).

2. If the engine fails to start, or if it starts and

stops again after several pulls, follow the inst-

ructions in the section „Cold starts“.

7.3 Switching off the engine

Emergency Stop procedure:

If it becomes necessary to stop the blower imme-

diately (in an emergency), set the ignition switch

(Fig. 1/Item 4) to „OFF“.

Normal procedure:

To switch off the engine, push back the throttle

lever catch so that the engine runs in idle mode.

Then move the On/Off switch (Fig. 1/Pos. 4) to

„OFF“.

Anleitung_3436062_LB3.indb 11Anleitung_3436062_LB3.indb 11 01.06.12 12:5301.06.12 12:53

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 29 30

Commentaires sur ces manuels

Pas de commentaire

Florabest FBLB 33 A1 Manuel d'utilisateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel de jardinage Florabest FBLB 33 A1